Sharper Image EC-WS115 Manuel d'instructions télécharger pdf (Page 19)

REPLACING AND CHECKING THE CARBON BRUSHES

In order to keep your tool running correctly, you need to check your carbon brushes after

every one hundred hours (100 hrs) of use. Carbon brushes wear out over time based on

tool’s usage. If a carbon brush is worn out, it may cause the motor to malfunction or fail

torun.Thecarbonbrushesshouldbereplacedwhentheyareworndowntoaquarterof

aninch(1/4”)insize.

DANGER!

Be sure to unplug the power cord from the outlet before assembling or disassembling the

tool. Accidental starting of the motor may cause bodily injury.

CARBON BRUSH REPLACEMENT

1. Locate the Carbon Brush Caps at the rear of the motor (one on each side) as shown

in Figure 17.

2. Unscrew cap completely until carbon brush assembly releases from brush holder as

shown in Figure 18.

Figure-17

Carbon Brush Cap

Figure-18

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Pas de commentaire

Sharper Image EC-WS115 Manuel d'instructions Page 19