Sharper-image CA900 Manuel d'utilisateur

Hot Gel+Lather Shaving SystemCA900 InstructionsRead and save these instructions.

4. Turn the dispenser over and depress the LOCKING TAB.5. Carefully align the gel or lather valve with the center seal of the dispenser.6. Gentl

8. To use the dispenser with gel, depress the black CONTROL CAP firmly and slide the ADJUSTMENT switch to the outer-most GEL position. (See Figure 4.

1. Ensure lather can is inserted correctly into the dispenser. (See Figure 3.) Also ensure the lather nozzle is attached to the dispenser.2. Pr

4. After a few minutes, the red indicator illuminates.5. To release heated gel into the palm of your hand, press the GEL RELEASE button located on

Problem: Gel is too runny. Solution: Adjust TEMPERATURE CONTROL DIAL to a lower setting.Problem: Unit fails to heat. Solution: Ensure the unit is plu

15WARNINGKEEP AWAY FROM WATERIF YOU THINK THE POWER IS OFF WHEN THE SWITCH IS OFF, YOU'RE WRONG.Everyone knows that electricity and water are a d

WarrantyWhat Is CoveredThis warranty covers any defects in materials or workmanship, with the exceptions stated below.How Long Coverage LastsThis warr

Table of ContentsImportant Safety Instructions ...3General Instructions ...

IMPORTANT SAFETY INSTRUCTIONSWhen using an electrical appliance, basic precautions should always be observed, including the following:READ ALL INSTRUC

IMPORTANT SAFETY INSTRUCTIONSWARNING• To reduce the risk of electric shock, this appliance has a pola-rized plug (one blade is wider than the other).

IMPORTANT SAFETY INSTRUCTIONS• Never operate the appliance if it has a damaged plug or cord, if it is not working properly, if it has been dropped or

Variable Temperature ControlThis unit is equipped with a variable temperature-control dial. Adjust it until the gel or lather is heated to a comfortab

Parts DiagramGel NozzleGel Release ButtonAdjustment SwitchPower ON ButtonReady Indicator LightPower OFF buttonVariable Temperature ControlLocking

IMPORTANT NOTES • Oversize lather cans may not fit into the protective base.• The Control Cap works without the protective base.• Caution: Do not bl

Figure13. To remove the plastic cap from a gel or lather can, use the Cap Removal Tool located in the base of the unit. (See Figure 2.)Figure 2Steps